Featured Discussions

Membership Chair

Commanders on the Chesapeake; Regional Rendezvous 2017 - TIME IS RUNNING OUT!


Started by Matt CowlesLatest Reply


Want a flying start? Read me first!

Posts with the most recent activity are sorted on top.  To read a post; just click on the headline. You can respond to the main topic or to…

Started by CCCC WebmasterLatest Reply

Discussions Replies Latest Activity

HELP! Cutless (cutlass) bearing size

I'm replacing the cutless bearings in my 30' Commander. My best measurements of the ID and OD of the installed(old) bearing are ID-1.25"…

Started by paul heid

10 1 hour ago
Reply by Kevin McKinnon

Timeless evening

Met with Mike Watson at Grafton Harbor, seems he had the Rendezvous date off by several months.  It was good to visit with he, his son and…

Started by Timothy "Tim" Miller

0 7 hours ago

Gate Hardware

I'm looking for one of these. Chris Parts doesn't have one. Any other resources, I've been checking Ebay but to no avail. Scroll picture do…

Started by Steven Kuhlmann

3 9 hours ago
Reply by Todd & Patty Walters

47 Commander Bahamas Deja Vu?

While helping a friend with his annual Bahamas trip...(lucky me right?)...I stumbled upon the very Commander on our website headline page a…

Started by Paul Cavenaugh

4 12 hours ago
Reply by Hunter Wright

Water flow thru trans oil cooler

I've got the exhaust risers and elbows off, and since I'm doing that I figure I should correct my cooling system plumbing as well. Whoever…

Started by Jim Frens

6 18 hours ago
Reply by Steve

To Wedge or Not to Wedge.... That is the question

Wanted to get some feedback from other Commander owners if they use a Carburetor Wedge on their gas engines. I will be pulling the Carbs th…

Started by Russell Moore

9 yesterday
Reply by Mike H

Flybridge steering assembly

Take a look at the picture. This plastic piece is worn. It still works. As my f/b steering is readied for assembly, I wonder if any members…

Started by Steven Kuhlmann

9 yesterday
Reply by Steven Kuhlmann

Osco exhaust parts ?

While working on my holding tank plumbing (not a pleasant job, but at least I found the leak) I had to remove the port side exhaust hose. I…

Started by Jim Frens

21 yesterday
Reply by Jim Frens

Laying down tile and galley proper wall wood replacement

1970 chris craft commander 42'Hello I am planning to replace my galley section of the wall then lay tile down and up against the wall becau…

Started by Jamie Paruszewski

1 yesterday
Reply by Al Edwards

Performance Distributor

Months ago I ordered and had installed a Performance D.U.I. distributor for my port 427 engine. That engine has never started as easily or…

Started by Steven Kuhlmann

6 on Tuesday
Reply by Steven Kuhlmann


Club News

Photo Contest Winner!

See more details in this forum post.

A photo album with all contributions is displayed below in or Photo Album section.


Commander Styling Story

© 2017   Created by CCCC Webmaster.   Powered by

Badges  |  Report an Issue  |  Terms of Service