Tim Toth's Discussions (163)

Discussions Replied To (138) Replies Latest Activity

"Captain Chris  .........   Fyi  , when chasing cabin leaks  dont forget the " stanch…"

Tim Toth replied Oct 8 to Toe Rails - Caulk the Joint or Lift and Replace

11 Oct 8
Reply by Tim Toth

"Captain  Doug .......  I agree the  weights  that we posted are a bit apart . I woul…"

Tim Toth replied Sep 18 to 410 Commander Cruise speed/rpms

13 Sep 20
Reply by William (Bruno) Millonig

"Captains ........  The  41 / 410  listed weights in the models section here is an ob…"

Tim Toth replied Sep 18 to 410 Commander Cruise speed/rpms

13 Sep 20
Reply by William (Bruno) Millonig

"Captain  Ben ....... The info I have for you to compare is  from a `72  41 with no b…"

Tim Toth replied Sep 17 to 410 Commander Cruise speed/rpms

13 Sep 20
Reply by William (Bruno) Millonig

"Captain   Mark  ...........  The  info I have  was sent to me from  Prestolite / Mal…"

Tim Toth replied Sep 3 to 350q distributor, advance springs

5 Sep 5
Reply by Dick Morland

"Captain  Tom ........  The  90 degree exhaust elbow on that model engine  as install…"

Tim Toth replied Aug 28 to Rusty Exhaust Water

5 Aug 28
Reply by Tim Toth

"Captain   Tom  ......... Your  rusty water issue is very likely the cast iron 90 deg…"

Tim Toth replied Aug 27 to Rusty Exhaust Water

5 Aug 28
Reply by Tim Toth

"Captain  Dan  .........  You can go to  www.daytonaparts.com for your Carter carb re…"

Tim Toth replied Aug 27 to 35 Commander, carburetion

3 Aug 28
Reply by Paul Tuomi

"Captain  Bill ........  You mentioned fitting the fuel vent overflow tube from fuel…"

Tim Toth replied Aug 27 to 23 Lancer Quadrajet Woes

7 Aug 27
Reply by Tim Toth

"Captain  Bill ...........  When you re-powered to the 350 long block did you keep th…"

Tim Toth replied Aug 27 to 23 Lancer Quadrajet Woes

7 Aug 27
Reply by Tim Toth

RSS

Club News

Styled In Fiberglass

For your reading pleasure, the latest issue of the Chris-Craft Commander Club's newsletter, Styled In Fiberglass, along with past issues, can you accessed through the link below.

Styled In Fiberglass Issues

________________________________________

The 2018 Chris-Craft Commander Club National Rendezvous is in the books and it was a great time!!

City of Mentor, Ohio

The city of Mentor, Ohio and the Lawnfield Inn & Suites were wonderful hosts.  A special Thanks to Rob Kneen, the local member sponsor, and Char Pike for the hours of hard work put in organizing and coordinating an amazing weekend. 

The Rendezvous Photo Albums can be accessed through the links below, as well as, under Library, Photo Albums.  We will continue to add links to other albums as they become available. Also below, you will find links to a couple articles written for the local newspaper.

Photo Album 1                 Photo Album 2  

Photo Album 3

Articles:

Chris-Craft Commander Club Celebrates Anniversary in Mentor

Chris-Craft Commander connoisseurs congregate at Mentor Lagoons Marina

_________________________________________

 

© 2018   Created by CCCC Webmaster.   Powered by

Badges  |  Report an Issue  |  Terms of Service