Russell Moore's Discussions (70)

Discussions Replied To (64) Replies Latest Activity

"I did change back to 3 blade props.  the 2016 props were 17x17... then I went to 19x…"

Russell Moore replied on Friday to Use of Zinc Prop Paint

4 on Saturday
Reply by Chris Wickersham

"I managed to get out for about 90 minutes last night... it was very nice.   I manage…"

Russell Moore replied May 15 to Drill a Hole In Distributor Cap!

18 May 15
Reply by Russell Moore

"Looks like everyone has loaded up the list of potential solutions... all I want to s…"

Russell Moore replied May 15 to Engine RPM Drop Question

19 May 30
Reply by Mark Regenhardt

"Ok... so lets through this out there.  the PO installed the engines in 2011 and I've…"

Russell Moore replied May 14 to Drill a Hole In Distributor Cap!

18 May 15
Reply by Russell Moore

"Tim you are reading my mind~!... I bought a new coil to swap out... but opened the b…"

Russell Moore replied May 14 to Drill a Hole In Distributor Cap!

18 May 15
Reply by Russell Moore

"Matt,  thanks for the comment. I have checked the timing on this engine.  I do know…"

Russell Moore replied May 14 to Drill a Hole In Distributor Cap!

18 May 15
Reply by Russell Moore

"I've listened to you and not done hole.  Today FINALLY had another run  after going…"

Russell Moore replied May 13 to Drill a Hole In Distributor Cap!

18 May 15
Reply by Russell Moore

"Point taken guys.  when it was suggested as a solution it didn't seam right.  In the…"

Russell Moore replied May 4 to Drill a Hole In Distributor Cap!

18 May 15
Reply by Russell Moore

"I have 350K engines  with conversions (same conversion as your 305 Short Block).  Th…"

Russell Moore replied May 3 to 305 K engine heat exchanger conversion

1 May 3
Reply by Russell Moore

"Update,  PHEW! Starter rebuilt $200, connect 2 wires and 3 bolts... up and running. …"

Russell Moore replied May 3 to Engine Stall... Transmission goes Clunk Clunk Grind

13 May 3
Reply by Russell Moore

RSS

Club News

Registration Is Open!!

City of Mentor, Ohio

What: 2018 Chris-Craft Commander Club National Rendezvous

When: July 27 - 29, 2018

Learn everything you need to know about the 2018 Chris-Craft Commander Club National Rendezvous by clicking the link below (You can register here too!!):

2018 Rendezvous Site

_________________________________________

 Chris-Craft Commander Club YouTube Channel

In an effort to expand the video sharing for the club, we have built a YouTube Channel. We hope you enjoy watching the wonderful videos our members have chosen to share.    

  Click Here To Learn More

_________________________________________

© 2018   Created by CCCC Webmaster.   Powered by

Badges  |  Report an Issue  |  Terms of Service