I have 2.5:1 Paragons and am going to replace the original CC transmission pressure gauges.  Since they have never worked I am wondering what the correct pressure would be so that I can select the proper psi range for the new gauge.  The original CC gauge has a range of 0-200 which is fine if it runs at 100psi but if it runs lower I'd rather select a range that the running psi is around the middle of the gauge range.

Thanks.

Pat

Views: 287

Reply to This

Replies to This Discussion

they run about 125psi

Good Afternoon. Did you ever replace your guages and sending units ? If so what did you replqace them with ? I also have p44 paragons ans was wanting to do the same. Any help would be great. Thank you  Augie

Reply to Discussion

RSS

Club News

Styled In Fiberglass

For your reading pleasure, the latest issue of the Chris-Craft Commander Club's newsletter, Styled In Fiberglass, along with past issues, can you accessed through the link below.

Styled In Fiberglass Issues

________________________________________

The 2018 Chris-Craft Commander Club National Rendezvous is in the books and it was a great time!!

City of Mentor, Ohio

The city of Mentor, Ohio and the Lawnfield Inn & Suites were wonderful hosts.  A special Thanks to Rob Kneen, the local member sponsor, and Char Pike for the hours of hard work put in organizing and coordinating an amazing weekend. 

The Rendezvous Photo Albums can be accessed through the links below, as well as, under Library, Photo Albums.  We will continue to add links to other albums as they become available. Also below, you will find links to a couple articles written for the local newspaper.

Photo Album 1                 Photo Album 2  

Photo Album 3

Articles:

Chris-Craft Commander Club Celebrates Anniversary in Mentor

Chris-Craft Commander connoisseurs congregate at Mentor Lagoons Marina

_________________________________________

 

© 2018   Created by CCCC Webmaster.   Powered by

Badges  |  Report an Issue  |  Terms of Service